CSXi: Passing the Toyota test

Posted by AuCom on 5/22/19 10:47 AM

Around the globe, Toyota are well known for being at the forefront of process innovation; setting high standards with a high level of attention to detail. Their newest production facility in the township of Caleras de Amexhe in Guanajuato, México is no exception to this rule. We're proud to say that the AuCom CSXi has passed the Toyota test, with multiple CSXi units already installed at the new facility that is expected to begin full-time production by the end of 2019.

Each vehicle manufactured by Toyota must go through multiple tests before going to the market. One of the most common tests consists of a water shower applied to the outside of the vehicle to verify that there is no ingress of water into the vehicle.

To perform this test, the vehicle is placed in a shower test room which sprays water at constant pressure through a hydraulic spray system divided into three sections: lateral (both sides), upper and lower (as shown in figure 1). Each section has an independent water distribution system, so it is necessary to implement a pumping system for each section.

Read More

Topics: Projects, Soft Start Control, System Design, Pumping, Water Hammer, Industry Applications

Irrigation Association calls for smarter irrigation citing importance of water and energy efficiency

Posted by AuCom on 8/18/17 10:07 AM

In the United States, irrigated agriculture produces about half of the total value of crop sales despite comprising only 17 percent of U.S. cropland. However, irrigated agriculture also represents the largest share of consumptive water use in the nation. Efficient agricultural irrigation helps to balance the incredible value of irrigated agriculture with the need to be conscious of water use.

- Irrigation Association

The Irrigation Association has recently released a new paper titled Principles of Efficient Agricultural IrrigationThe document discusses the key concepts that users and providers of irrigation need to consider to attain the most energy efficient use of water and energy.

Read More

Topics: System Design, Pumping, Irrigation, Energy Efficiency, Industry News

Protect your pumping system from the damaging effects of water hammer

Posted by AuCom on 12/5/16 9:44 AM

Water hammer has the potential to cause significant damage to pumping systems. Most in the pumping industry have a tale to tell about burst or collapsed pipes, or broken or damaged valves, pressure gauges and even pumps.

Solving the water hammer problem requires either mitigating its effects or preventing its occurrence altogether. To this end, there are a number of solutions to consider when designing a pumping system, including electronic motor control.

Electronic motor control devices such as soft starters and variable frequency drives can be used to control the speed of the pump during starting and stopping. This allows for a more gradual increase or decrease in pump speed, preventing water column separation, flow reversal and sudden check valve closure – a few of the primary causes of water hammer.

Read More

Topics: Water & Wastewater, Soft Start Control, Pumping, Irrigation, Water Hammer, Industry Applications

Welcome to the AuCom newsfeed

Here you'll find the latest news and industry insights from AuCom and the world of motor control. Please feel free to comment and share, or sign up below for updates straight to your inbox.

Subscribe to Email Updates

Recent Posts